 Lill Putt-Putt
|  |  Has doors and also pleciglas inserts for top half of doors, those are stored in ceeling of the cab
|
 |  Cab has room for 3
|  windshield viper is hand operated
|
 Bench seat from a Nissan Pickup truck
|  6 hp Fairbanks-Morse "Z" enclosed Crank, Great Running engine.
|  The fuel Mixer has been replaced with an Zenith updraft carb for better engine speed control. Trottle control in cab!
|
 12 volt El system
|  12 volt starter/generator from an garden tractor, with belt around flywheel for starting.
Not used for charging battery as I changed the pulley to the smallest one I could fit, so it turns to fast for using it as a charger!!
|  12 volt generator driven of pulley.
Output is 12.5 at idle to 13.5 volts at higher RPM
|
 Compression release. Holds Exhaust Valve open, in order for starter to turn engine over, when engine is turning and compression release is disengaded engine will start very easy
|  Input shaft to transmission is driven by 2 "V" belts from crankshaft pulley, picture shows belts engaged.
|  Spring loaded idler pulley is used as clutch, Works great! transmission shift with ease.
|
 Spring loaded idler pulley is operated by clutch pedal by a cable.
|  Clutch and brake pedal is Org.
Pedal to the left is for the Compression release, works by cable and a couple pulley's in order to hold the Exhaust valve open, in order to get the engine turning over!
|  Instument panel! only Spedo, water temp and Volt Meter is working!
|
 kenwood Radio/Casette player
telephone for looks only!!
|  Rear Diff. From a Chevy??
|  Old freon Tank used as gas tank, plastic hose on Right is the fuel gauge!
|
 Rebuild Fairbanks - Morse magneto
|  This is a short video of starting the engine, Etc.
|  This is a short video of the engine running!
|
