25 Rods and pistons look good.
| 26 Need some stands now to split it and pull the crankshaft out.
| 27 Got # 2 split.
| 28 Now need to pull the clutch and flywheel off.
|
29
| 30
| 31 Our stands could use some caster wheels but it works no heavier then this engine is.
| 32 And there is what we found once we pulled the crank shaft out. Bearings are beyond done!
|
33
| 34
| 35 I think the crank shaft might be ok. Don't know about those grooves where the seal runs though.
| 36
|
37 # 4 piston journal. Looks questionable but Andrew was able to scrape a lot of it off as it's bearing build-up.
| 38
| 39
| 40 Work on tractor # 2 is on hold for now, going to try and get # 1 running first now.
|
41 Finally getting back to work on #2. Andrew got main and rod bearings for this one. Working on getting them installed.
| 42
| 43 Andrew torquing rod bolts down.
| 44
|
45
| 46
| 47 Had a bit of a cooler morning and was able to get a little work done.
| 48 Was able to get the flywheel put on and got it slid back together.
|