Photo 260 of 415, 1942 WC52 3/4 ton

I ground out the bad and cleaned the area up with a carbide burr. Welding cast is more difficult than normal steel or cast steel. For structural stuff and critical safety things you'd preheat and use a different method than what I'm going to do. This is basically just getting it closed up again. I start by bending some copper to match the inside contour I want to fill. This will allow for easy buildup and a heat sync at the same time.

	sec delay
I ground out the bad and cleaned the area up with a carbide burr. Welding cast is more difficult than normal steel or cast steel. For structural stuff and critical safety things you'd preheat and use a different method than what I'm going to do. This is basically just getting it closed up again. I start by bending some copper to match the inside contour I want to fill. This will allow for easy buildup and a heat sync at the same time.
Full EXIF / IPTC Photo 260 of 415, MVC-008S_13.JPG, 26KB, 640x480, 85 Hits Other Sizes: Original Medium Large
Properties \| Link	Back to Thumbnails