Now the inner axle, universal drive coupling and outer drive shaft is installed with lubricant as described in the Dodge Shop Manual. Then the Spindle is bolted on with
1/2" x 13 bolts. New Grade 8 is recommended. On my truck the rotor and hub is installed as I have disk brakes. The Dodge Shop Manual describes the correct procedure for tightening the hub retaining nut, lock ring and 2nd retaining lock nut. Before installing your original hubs, Pull the rear snap ring, drive out the seal and remove the inner wheel bearing and clean and inspect. If any question of quality, replace it. The same holds for the outer wheel bearing. Repack with high temperature grease and install.
1/2" x 13 bolts. New Grade 8 is recommended. On my truck the rotor and hub is installed as I have disk brakes. The Dodge Shop Manual describes the correct procedure for tightening the hub retaining nut, lock ring and 2nd retaining lock nut. Before installing your original hubs, Pull the rear snap ring, drive out the seal and remove the inner wheel bearing and clean and inspect. If any question of quality, replace it. The same holds for the outer wheel bearing. Repack with high temperature grease and install.
Other Sizes: Medium