ISO auxillary outlet conversion

Dan Allred | Home >

ISO auxillary outlet conversion

Installed a new ISO kit in auxillary hydraulic outlet to convert from old IH tips

Date(s): February 26, 2008. Album by Dan Allred. 1 - 13 of 13 Total. 1775 Visits.

Sign the Guestbook. There are no entries.

1 DSCF8010 Install new sealing rings in grooves. 2 sets per hole	2 DSCF8014 Notice the small pilot hole by the threaded hole	3 DSCF8015 Install coupler body into housing	4 DSCF8016 Install stepped washer with small OD toward body and tighten bolt
5 DSCF8017 Invert housing to install rubber boots	6 DSCF8018 Cut a groove in the bottom of boot for the oil to drain. Make sure you do it to the bottom	7 DSCF8019 I used a die grinder. It just takes a little bit	8 DSCF8020 Lubricate boot and install in housing
9 DSCF8021 Boot should go down flush to allow the snap ring grooves to align	10 DSCF8022 Installing other boot	11 DSCF8023 Install snap ring with the kit into grooves.	12 DSCF8024 More of the snap ring going in
13 DSCF8025 The finished outlet installed

Select All.