Mercury Vapour Lights-hockey
Check out the variations in the lighting, despite the camera being set on manual. Olympus E-330, ISO 640, f/2 and 1/500th.
Wiki explanantion: "At the end of life, high-pressure sodium lamps exhibit a phenomenon known as cycling, which is caused by a loss of sodium in the arc. Sodium is a highly reactive element, and is easily lost by reacting with the arc tube made of aluminum oxide and the products are sodium oxide and aluminum:
6 Na + Al2O3 → 3 Na2O + 2 Al
As a result, these lamps can be started at a relatively low voltage but as they heat up during operation, the internal gas pressure within the arc tube rises and more and more voltage is required to maintain the arc discharge. As a lamp gets older, the maintaining voltage for the arc eventually rises to exceed the maximum voltage output by the electrical ballast. As the lamp heats to this point, the arc fails and the lamp goes out. Eventually, with the arc extinguished, the lamp cools down again, the gas pressure in the arc tube is reduced, and the ballast can once again cause the arc to strike. The effect of this is that the lamp glows for a while and then goes out, repeatedly.
More sophisticated ballast designs detect cycling and give up attempting to start the lamp after a few cycles, as the repeated high voltage ignitions needed to restart the arc reduces the lifetime of the ballast. If power is removed and reapplied, the ballast will make a new series of startup attempts.
LPS lamp failure does not result in cycling; rather, the lamp will simply not strike or will maintain its dull red glow exhibited during the start up phase." |
Date(s): Nov 27. Album by Barry Stewart. Photos by Barry Stewart. 1 - 15 of 15 Total. 227 Visits. |
|
